Lava-computer DSerial-PCI/LP Card Manual de usuario descargar pdf (Pagina 3)

DOS and Windows 3.x Installation

1. With the power turned off, insert the DSerial-PCI/LP card into any

free PCI slot in your PC.Turn your PC on.

2. Place the DSerial-PCI installation diskette into your floppy drive.

In the Win3.11\16550 subdirectory of this diskette you will find a file

called“Lavaconf.exe”. Copy this file to your hard drive and run it.

3. When run, Lavaconf.exe will display two I/O addresses and one IRQ.

These correspond to the addresses and IRQ chosen by your PC when

configuring the DSerial-PCI . Make a note of them.

4. If you are using Windows 3.x, start Windows and go to Control Panel

| Ports. Choose Com 3 for Port 1 and Com 4 for Port 2 on the DSerial-

PCI . Click the Advanced button and enter the I/O address and IRQ

for each port as reported by Lavaconf.exe. Reboot your PC for these

changes to take effect.

Note: DOS and Windows 3.X support a maximum

of four Com Ports in a PC.

/LP

1 2 3 4 5 6 7 8

Sin comentarios

Lava-computer DSerial-PCI/LP Card Manual de usuario Pagina 3